truck suddenly won't crank, why not??
drove the truck for two days, let it sit for a day, then drove it again. Drove it to work, around town and then home (30 minute drive home). It had been starting fine all day, and ran like a top. I...
View ArticleEGT sensors not covered by powertrain warranty if anyone was wondering......
Well last week the wife was driving the truck and got a check engine light followed by a "stop safely" message. She pulled off the road that the truck shut off. I read codes P200c, and P200e. A google...
View ArticleCatalytic converter plugged
I have a catalytic converter plugged on an 08 6.4 I just bought a month ago someone suggested run without it but would have to have a special programmer any ideas or suggestions?
View Article2013 F250 stuck in 4WD HI
I have a 2013 powerstroke, lariat, fx4. After using the 4WD LO I attempted to select 2WD. I selected 4WD HI first. The info center illuminated "shift in progress" then "delayed shift pull forward"...
View ArticleEngine Dead - No compression #2 - Questions...??
So, somehow I have lost cylinder 2, most likely due to failed injector. The shop guys is still digging to see how bad it is, if piston is messed up or valves or what. My question. I had rebuilt this...
View ArticleGen2_ 6.7..?
Hey guys, got a 2014/2015 question Tried this question in the new guy forum, got no response. Help out a Chevy guy trying to switch over make the best choice... Been doing a lot of reading here and...
View ArticleLooking for expert help, dealer disconnected wire
So, upon coming back from the dealer to do a inspection on my truck, I popped the hood and noticed a disconnected wire! Being new to this engine, I have no clue what it is, does, or why it's now...
View ArticlePlease help with blower motor issue
I am having problems with the front blower motor on a 1997 e350 PSD. When I turn on the controls all I get is a light low air out of the blower no matter what the direction or blower speed selector. I...
View ArticleHose coming off of the inlet air filter box
I haven't learned anything new about my truck today so I thought I might ask what this hose is all about, anybody know? It appears to be stuffed inside the header panel with a clear sticker covering...
View Articleturbo upgrades
Will it change the way a turbo acts and sounds if the resingnator plate is removed? Also where Can THAT Be Found On a 2001 7.3?
View ArticleTransmission question (I screwed up)
Hey guys, I pulled the trans and transfer case out of my 02. When I separated the 2 I unbolted at the wrong spot (Transmission) I want to bolt the coupler back to the trans and unbolt at the transfer...
View Article2014/15 Steering Wheel Audio/Phone controls
Any of you have the Audio/Phone/Sync steering wheel control on the right side like this picture? I had this control on my 2011 with Nav radio and the "OK" button sure did come in handy with voice...
View Articlelong crank.....runs fine
Hey guys, new to posts, but have read more on here than when i was in school. So I know there are a lot of threads on this and i think i had read them all. I recently purchased a 2000 f-250 7.3l with a...
View Articlerv water heater element question
I thought I would ask here instead of registering on an rv forum, I'm replacing the water heater element in my rv and noticed that the two wires attached to the element don't seem to have any marked...
View Articleidles fine, missing at 1500-2000rpm
Need some help from the Ford pros. I have a 2004 F250 6.0 powerstroke. the issue just started all of sudden. Drove about 60 miles one day, fueled up, and parked. Crank the the truck next day, idled...
View ArticleNew HPOP, New codes
Just installed a Terminator T500 a couple of weeks ago. Since installing it I no longer get the P1211 on hard acceleration. Now on every single cold start I get a P1212 and a P0236 which I've never...
View ArticleFinally gonna do the rsk, have a few questions.
Hey guys i recently replaced all my front suspension parts, 1997 f350 crew cab longbed,7.3 diesel, trucks drives great now, on a flat nice freeway, its back to riding like a solid brick in town, was...
View Articletrouble with rear pinion seal
I was replacing the rear pinion seal on my 06 f350 and when I broke the drive shaft loose the wheel chalk didnt hold and the truck rolled now when I put everything back together I got a lot of play in...
View ArticleCranks but won't turn over..
So I have a 2006 F250 PSD XL 2wd.. 1920.000 miles. Recently i started to notice my degas bottle getting low a lot.. like a gallon low. I pulled my EGR and cleaned it, noticed it was a little "gummy",...
View ArticleEngine oil pressure sensor bad ? Help please
Hey there I recently pulled out my hpop to do diesel orings non service plug repair followed instructions and my truck fired up after about 13 seconds of cranking I let it run for 20 minutes and then...
View Article