customer truck with an odd code, need help!
A customer of mine has an 01 F250 4x4 with a 7.3. This truck keeps popping a P1274 code (Cylinder 4 (E) High to Low side open), it has also, one time, popped a 1276 (which is cyl 6). It has also had a...
View ArticleOld, old threads on How toos
Anybody have any idea on where to look for the old old stickys on like How to change trans fluid, how to change front hubs, etc thanks
View ArticleHub differences
I replaced my right side hub today (left side about a year ago) and was interested in knowing the difference in hubs with fine and coarse thread wheel studs. The difference in price can be upwards of...
View Article92 F250 trany od lite on
about week ago the od lite would flash when very slow speed or idle. Took it to a shop who ran codes, they thought problem was rpm sensor. I had noticed that tach would not register any RPMs until...
View ArticleH&s minimax
Wondering if some one can help me. I have a dpf-r tunner and bought a h&s minimax do you know if I have to put everything back to stock to install minimax?
View Articlereplacing front crank shaft seal in 92 F250
Is it possible to replace front seal without pulling timing gear cover? I know book says to remove gear cover but I was wondering if I remove radiator and fan and harmonic balancer if I would be able...
View ArticleHello from the home of Super Bowl champ Seahawks
Checked out this site for some help I needed on my 02 F350. There are some really knowledgable people here and I am excited about being here. I have a 2002 F350 Super Duty crew cab dually with the 7.3L...
View Article1999 E350 7.3 Turbo Diesel
This van only has about 60,000 miles on it and that is because I had a remanufactured engine put in it in 2007. My problem is that if it is 45 degrees out or less it will not start, I do wait until the...
View Articlecoolant in exhaust,has egr delete,help!!
I have coolant in turbo and exhaust, think 3 bad injectors, is this from blown head gasket? and another problem I pulled each injector plug off one at a time to see if they were hitting and after I...
View ArticleCracked heads and magnafluxing
This is kind of a general questions that is really too difficult and complicated to explain why I need this information. It is my understanding that all heads on a 6.0 will crack after so many miles...
View Article4X4 doesn't work
I have an '05 f350 with a 6.0l that has dual alternators (if that makes a difference). 4wd quit working, I have tested the solenoids, relays, mss, shift motor on transfer case, etc. I have found that...
View Article2012 Torqshift Tranny Problems...I think
Hello guys, New to the forum and looking for some expertise. I have a 2012 F350 FX4 dually with 111,000 miles. The truck is a hot shot truck so it is hooked to a trailer about 85% of the time. I hauled...
View Articlestandpipe/dummy plugs oring set
Can we buy a oring/seal set for the standpipe/dummy plugs or do we have to buy the whole standpipe? I have read about new stile pipes, are they redesigned pipes or just new oring seals? I just ordered...
View ArticlePower Steering Pump Replacement
For a month now I've noticed my power steering going out on me. When I turn in one direction....the power steering goes out....to get it back I have to turn the wheel the opposite direction and then...
View Article'03 6.0L Starts and Idles great, No Power Under Load
I've got an early build '03 with 149,000 miles. The truck starts great and idles normally, everything sounds normal. I can rev the engine while in park or neutral, but when I put it in gear, the engine...
View ArticleClik here to view.
Dieselstie Billet Thermostat housing w/ oring
Has some scratches along front edge due to tough access on a e350 (van), but doesn't have impact on its function and once installed you will never notice or see the scratches. Fits 99-03 7.3l, comes...
View ArticleParts List for Bulletproofing?
Hello all, i have a 2003 F350 with the 6.0L, i was wondering if anyone had a parts list so that i can begin ordering.. the motor is currently hydro-locked (coolant i believe), and i need to flush it...
View Article03 7.3L tranny cooler lines
I was wondering if anybody has used some 3/8" hydraulic hose to replace those crappy stock steel to rubber lines that always leak at the transition from rubber to steel. If so what fittings does a guy...
View ArticleRecirculate / blend door
I would like to know how to recirculate the air on my heater. The only recirculate i have is when it it is max a/c. The exhaust fumes are overwhelming when the heater is on. Can I add a toggle switch...
View Articlerumble grinding noise
okay so i have a 2003 ford f-250 4x4. when i start driving down the road around 30+ it has a loud grinding noise that gets worse when you get to about 55 - 60 then it quiets back out around 65+ also...
View Article