New to the forum, have a 6.0L
Greetings! New to the site as a registered member and relatively new to diesel ownership. I own a 2007 6.0l F-250 Lariat Outlaw 4x4 Crew Cab, 163,000mi. Truck has Magnaflo turbo back exhaust, Edge CS,...
View Article04 6.0 temp, oil in fuel issues
I have a 2004 6.0L that I am having a couple issues with. October two years ago I went through and done a bunch of work to the engine. Head gaskets, studs, egr delete, oil cooler, injectors, coolant...
View ArticleAC Clutch fuse #17 keeps blowing
I used the search function all day yesterday and didn't find an answer. I was getting nothing but warm air blowing through the vents. Found fuse #17 (under the hood) blown. After replacing the fuse,...
View Article6.4 oil can light (low oil pressure)
I have a 2008 6.4. When I do a cold start or start after its sat for a little bit it throws the low oil pressure light. When it does this the truck kinda shakes like a rough idle so too speak. I'm in...
View Article6.4 oil can light (low oil pressure)
I have a 2008 6.4. When I do a cold start or start after its sat for a little bit it throws the low oil pressure light. When it does this the truck kinda shakes like a rough idle so too speak. I'm in...
View ArticleClik here to view.
Crank shaft pulley gasket/seal
Checking to see if this is normal or something I should be concerned with. What I noticed (hopefully you can see it in the picture) is that it appears the seal/gasket on the inside of the pulley may be...
View ArticleClik here to view.
Diesel in coolant
I replaced the injector cups after i realized that there was diesel in my reservoir. I did a very thorough rinse out with a regular water and a bunch of distilled water. I have read that sometimes teh...
View Article"T" shirt sayings
NO, I DIDN'T FART. MY BUTT JUST BLEW YOU A KISS! I COULD BE A MORNING PERSON, IF MORNING HAPPENED AROUND NOON SOMEONE PLEASE TELL MY WIFE I'M RETIRED! HEAT MAKES THINGS EXPAND. SO, I DON'T HAVE A...
View ArticleClik here to view.
Mitchell under/over drive
I am looking for a Mitchell gear splitter Under/Over Drive like the one in the attached pic. I believe it is a model 3000C. If anyone has one or knows of one please let me know shepherd@quicklinks.ca...
View ArticleClik here to view.
90 Gallon in bed tank/toolbox
$450 plus shipping....Magnolia, TX Attached Thumbnails   Â
View Article2015 cab chassis questions
Hello everyone well I am not new to the diesel stop, as I've been viewing the forums for years. However, I finally decided to sign up and ask some questions. I am seriously considering ordering a new...
View Article"T" shirt sayings
NO, I DIDN'T FART. MY BUTT JUST BLEW YOU A KISS! I COULD BE A MORNING PERSON, IF MORNING HAPPENED AROUND NOON SOMEONE PLEASE TELL MY WIFE I'M RETIRED! HEAT MAKES THINGS EXPAND. SO, I DON'T HAVE A...
View ArticleTransmission acting nuts ??
(1 F 250 4x4 7.3 4OD, want out this am and after a few miles I notice the truck not shifting as always, and then I notice no matter how fast I want, the speedometer only want up to 25 or 28 MPH, and I...
View Article99 F350 7.3D 4x4 not working
Hi all, I am new to the site. I have a 99 1 ton with 295K miles. My ESOF does not work, and the abs light now comes on when I start the pickup but seems to go out when I put it in reverse. I took it to...
View ArticleKeeping dust out of the bed (shell/tonneau)
I have a tonneau cover on my 2008 long bed. I've installed a bed seal and covered every hole I can find but can't seem to keep dust and dirt out. Everything in the bed is coated after driving on dirt...
View ArticleSpontaneous starter
Hi and Merry Christmas to all, On one of my 2002 7.3 4X4 crewcabs I have a problem with spontaneous starter engagement while running. Also at times merely turning key to "run" will start cranking....
View ArticleFan blowing direction
2008 6.4 super duty air flow blowing out all locations but very little from defrost from full defrost is manually selected, most flow goes to floor with a little to the front vents
View ArticleClik here to view.
2002 F250 ESOF not engaging - Status - GEM
My ESOF hasn't worked for quite a while . (Transfer case motor engages, 4 low and 4 high works fine but never applies vacume to the hubs as the solenoid isn't getting the signal from the (GEM) General...
View ArticleNew return lines, etc
I have an injector leaking right at the top where the line comes in. I bought the Dipaco injector installation kit. I've never done diesel work before and I wasn't able to find details on how to...
View Article