New
Hi, I'm new. Just bought a 99 F-250 super duty W/ 7.3. I have been using this forum to get answers about many problems I am encountering. Very helpful. Tom
View Article2WD Leveling kit Advice?
I've been thinking lightly about how my truck would look level, since its 2WD and sits lower in the front. I leveled out my 04 Ranger 4x4 and it messed up the alignment a little but I got it fixed but...
View ArticleTrack Bar fun
I'm "helping" a friend replace the bushings on his track bar. Well, that's what it started out as. The driver's side bolt absolutely wouldn't come out. I sprayed it, pounded on the threaded side (with...
View ArticleNo dash lights... Well, some dash lights
In my main display, it seems that the right side has gone dark. That includes the guages next to the main supply. How much of a big deal is it going to be to fix the problem. It seems like it would be...
View ArticleAre my injector o-rings going?
Truck runs GREAT on the highway - lots of power, good turbo boost (new turbo), 500-600 deg EGT at 65-70mph, great fuel mileage. But, when I get off the highway hot, I can barely get the truck to creep...
View Articlehard start.....
my dad has 2004 6.0 with 230k on it. lately, he is having a starting issue. it will crank for 10 sec, runs rough(like on 4 cyl), then stalls. crank again, same thing. after a few minutes of doing this,...
View ArticleHELP; NO CRANK, NO START, IGNITION PROBLEM
drove home last night, overdrive light on the shifter started flashing, made it home fine. This morning i had a no crank, no start, no dash lights, just dead took apart the covers on steering column,...
View Articlelow compression smoking
I have a 2010 f550 27,000 miles 2,400 hours the oil is sludged and it is smoking oil analysis is clear i did a compression test 6 of the cylnders are 400 psi 1 is 340 the other is 300 engine was not...
View ArticleLooking for a 2013 F250 King Ranch
Hello everyone. I'm in the market for a 2013 King Ranch F250. My only catch is I can not take delivery until the end of September, when I get home from the Middle East. Any dealers out there with some...
View ArticleComplete Injector Install Question
I've pulled and installed a single injector, but I need some guidance on a complete pull and install. I'm overhauling the rig, and I am going to put new seals on all of the injectors. I drained the oil...
View ArticleClik here to view.
blackstone oil report? Bad?
I think I attatched my oil report, if it does not show up I will try again. My truck in in the shop for HG's oil cooler, and egr delete. I took this sample right before it went into the shop right at...
View ArticleStandard tranny? And rear end?
Have a 99 7.3 powerstroke what do you put in tranny when it is low like 90 weight gear oil or special kind? What grease do I need in the rear in. It is a 250
View ArticleWhat is my 7.3 PSD Worth
Going to sell the below truck being replaced by a 2014 F-450. What is a fair price for the below truck? Was thinking of asking $12K is that to much? Year: "early" 1999 Mileage: 112,000 F-350 Lariat,...
View Article4x4 issues
Alright so my truck is stuck in 4x4 I have no power going to my switch on the fly and have check all the fuses. Any ideas on what to do?
View ArticleGlow plug question
Shouldn't I have power at the glow plug bullet connector. Everything is checking out fine wires,relay,gp's but I don't have any volt reading at the connector.
View Articlenew to deisel
hi i just picked up a 93 f250 with a 7.3 idi turbo for $300.00 it has 130,000 miles on it and its been sitting for 3 yrs it has a power angle plow on it, it appears to have deisel in crank case the guy...
View ArticleClik here to view.
Smashed down pipe?
I was told that some Ford F 250 s have a what they call a smashed down pipe I guess? I was wondering if this is what they meant? And getting it replaced to a good 3 inch would do a bunch for my exhaust...
View ArticleIpr readings
I have a 95 psd that's running rough/Miss and have a snapon scanner but I cant seem to find what the readings should look like if they were good. Im trying to find out what my Ipr psi and % should be...
View ArticleThe mods have begun.... what next?
I just got my 7.3 Ex back on the road with an upgraded tranny. Edge CTS with juice, MBRP 4" turbo back and airaid cai. Everything installed easy without issue. Now I want more and am wondering where to...
View ArticleDifference between Injector Pressure Regulator and Fuel Pressure Regulator
Hey guys, I have an F250 6.0L Power Stroke Diesel. It started shuttering between 50-60mph with steady fuel. I found out it was probably a bad fuel injector on this forum, so I joined. I took the truck...
View Article