Stage 1 Single Shots and EGTs
I have searched and cannot seem to find an answer to this question, so here goes.... I have a 2001 that is pretty stock. I converted it to a 6 speed last year. It has the 6637 filter, 4" exhaust, ATS...
View ArticleExceptional long crank, unless I keep the key on first
I am having a problem that I think is fuel related. It started if the truck sat for a few hours, it would crank for about 15 seconds before it fires up. I determined that if I turn the key to on, and...
View ArticleClutch whistle while engaged
In 4th and 5th gear clutch rattles and whistles while accelerating or decelerating. No whistle at steady speed. Throwout bearing? Synchros? Gear oil? Any ideas are much appreciated
View Articlelosing power - pls help
I have a 2002 ford excurison with the 7.3L diesel. the engine light has been on for a while now and i know that it was a reduced power boost error. i was towing on saturday by necessity and had been...
View Article1991 F-250 4x4, 7.3, Banks Turbo 5-spd
Hi, I'm selling my 91 F-250 4x4 XLT Lariat, 7.3 with Banks Turbo, 5-speed, AC power windows & Locks, Tilt, Cruise 211K Miles. 4:10 gears. The truck is really clean with no rust, a couple small...
View Articletires and wheels aftermarket
hey I just leveled my 2012 F350 and want to put new tires and wheels on the truck. thinking 20 inch rims with 34 ish size tires 35 would be ok too provided they look ok. i am looking for pics of trucks...
View Article4R100 leaking at selector shaft.....
Is there a seal behind the shifting selector switch that can be changed out easily, or is it a internal seal ?? My selector switch and connector are constantly getting wet from trans fluid and I...
View Articlecarli or icon suspenion lift ?
I m in the market for a suspension lift. Im undecided on a 2.5 or a 4.5 inch lift and undecided on which brand icon or carli. I would like to hear from anyone who has a carli or icon kit and what they...
View ArticleDo I Need Weight Distribution
I just traded my 2009 F-150 in and got a 2011 F-350. My problem is that the hitch receiver is about 3" higher than my old one. The Reese hitch that I have is already down as far as it can go. It looks...
View ArticleNew BTM muffler for sale
Hey guys....I sold my 05' without ever installing my Walker BTM muffler.It's brand new in the box.I believe it's 3.5" in and 3.5" out. I'm in southern ohio (Dayton ) and would sure like it if somebody...
View ArticleTorque Convertor?
I just installed a Tony Wildman chip in my 99.5 7.3 AUTO. I let the truck idle until it was around operating temperature then left it in economy mode took off a little hard truck was running pretty...
View ArticleWhat is a good lift kit for 2007 F350 DRW
Do not see much out there for the DRW, or if there is, the kit description does not say it will fit one. What kits are good? Wanting to around 2.5", no more than 4" (still have to park it in a parking...
View ArticleCooled seats not blowing as they should
The cooled seats in my '12 lariat are no longer blowing as hard as they once did. To the point where I can hardly feel any effect. I had the dealer replace the filters for each seat, but still no...
View Articlewont start
I have a 2003 f250 with 6 .0 that wont start I changed the map sensor and cam sensor still no start any idea that I might try
View ArticleNo juice to starter solenoid when key turned
I can jump across the starter solenoid (located on passenger side inner fender) with the key in the "on" position and the truck starts fine. Its not getting any power to the "switch" wire that connects...
View ArticleNeed some help matching a interior color
I am installing a Autometer under dash gauge pod in my 2002 superduty and would like to color match I found the color code E (medium flint) but here is the problem the interior is two tone the dash is...
View ArticleNew Member New Purchase
Hi I'm new here but have been following these forums for some time now. Lots of info to be had around here. After reading and narrowing down my truck I have settled on a f-250 lariat crew gas. I have...
View Articlesector shaft nut size?
Can somebody tell me the size of the nut on the sector shaft of the steering gear? I think I used a 34mm socket when I installed the steering gear but it was not a perfect fit. I think its coming loose...
View ArticleMystery electrical problem
What is wrong with my truck? I can't figure out why I can't get any running lights on any trailer I hook up. Thought it was an issue in harness for trailer, replaced it, still doesn't work. Plug into...
View ArticleNew Member looking for assistance
Hello I am looking at purchasing my first diesel, a 2006 F350 dually from North Texas Truck Stop. I live in NJ and am considering flying out and driving home. Wondering if there are any members in the...
View Article