Fustrated NO START!
I have a 2000 F350 with a 7.3 Powerstroke. I have been unable to get my truck started. Any help would be appreciated. What I have: Engine turns over but seems not to get any fuel Very little white...
View ArticleBlack Smoke and Chugging
I haven't been to this site in 7 years because all has been good with my '04 with 170k miles on it. Today it started blowing white smoke on and off for a couple of miles then it stopped. A couple of...
View ArticleClik here to view.
F-250 Factory 18" Wheels & Tires
I have a set of Ford F-250 4x4 18" Alloy Wheels w/Michelin All Terrain Tires. Tires have 22K miles on them and were rotated every oil change. Center Caps & Lugs Nuts go with them. $900 for the...
View Article55,000Lb plus possible?
Not planning on it but is it possible to gross 55,001Lbs or more with a F250/F350 with the right trailer and hitch system?Local zoning nazis are claiming that my 1980 GMC general is illegal to be in my...
View ArticleHow to change the side mirror bulbs?
I have a 2011 F450 with lights in the side mirror I would like to know how to change them out and install LED bulbs...I don't see any screws to take it apart..Thanks
View Articleservice intervals for filters on Airdog
Roommate just picked up a 12 that came with an airdog system. Was wondering when to change filters. thank you
View ArticleF/S H&S mini maxx w/off road tune
Selling my tuner with overhead mount. I bought it 3-4 months ago for my truck and totaled my truck 2 months later on 15 DEC. Looking to get $1200 there is nothing wrong with it. It has the off-road...
View ArticleFuel/water separator question
The water separator I have uses either the R24s or R26s filters. I have been having a hard time finding good filters. Both of these filters are hard to come as it is. I ordered 2 online from a place...
View Articlefuel leak
I have a 1987 F150 with a 1995 7.3L dropped into it, this morning I went out to start her up and she fired up just fine, so I went into the garage to get something and when I came back out the truck...
View ArticleClik here to view.
6.0L PCM and Innovative SCT Programmer
6.0L PCM and Innovative SCT Programmer (manual trans) I have a Innovative Diesel SCT Programmer and corresponding 6.0L manual trans PCM that I no longer need. I never wanted to mess with my factory PCM...
View ArticleClik here to view.
No AE Communication with IDM
I am absolutely pulling my hair out and I am about to take it to a mechanic. I really enjoy working on my own rigs and until now have alway been able to repair my vehicles. This may have me stumped....
View ArticleRear Overload Shocks
I'm going to replace all my shocks soon. I occasionally pull a 24 ft gooseneck equipment with a 9K to 10K tractor on it. Probably gross weight in the 13K range. What rear shocks would you all...
View ArticleFactory fiberglass running boards
WTB set of fiberglass factory running boards for reg cab pm info thanks
View ArticleClik here to view.
Beware of removing injector cups!!!
Alright folks, I rebuilt my engine and redid just about everything within the engine including the injector cups. I was going to wait and replace the injector cups while the heads where on the block....
View Articlehpop..seals or whole unit
Howdy all..at what point do you go from replacing seals on hpop to installing whe "new" unit? Got quite the oil leak from the hpop and ipr area. thx in advance!
View ArticleNeed some help with brake line extensions.
Hey. Just spent the day installing my rsk. Brake lines are too short to put the calipers back on. Went to the parts store and met a backyard mechanic who mentioned adding pieces of flared 3/16" tubing...
View Articleanother weak/long start
the wifes 2000 X is (sometimes) taking 10 sec + to fire up. i.e. it spins and spins. its generally happening after it has sat for awhile( a few min to a few hrs) hooked up the AE and heres what i got...
View ArticleFront Driveshaft issues
Hi All, I was replacing the u-joints on the front drive shaft this weekend and I think that I mixed up the orientation of the double cardan joint. I'm getting a vibration when in 4wd is there a trick...
View Article1999 7.3 turbo suggestions opinions welcome!
Hey guys well my turbo recently went out and I was wondering what kind of turbo you guys would suggest me getting. I don't want to go over 20 pounds though. I know a ford turbo goes for about 1500...
View Articlerunning rough
Hello all, I have a 06 6.0. All winter its not been wanting to start unless its plugged in. If its plugged in, it starts just fine. Last Thursday on my way to work, it was running rough, like 1...
View Article