So I drove through a puddle I did not know was deep on an exit ramp today.
Not real deep but when getting off a highway they seem deep at that speed.
I experienced no problems immediately afterward which involved a couple of miles after puddle and about twenty miles back.
It sat afterwards in rain all day of course for about six hours. I drove it about ten miles shut it off for one hour. Upon returning home I get a tiny single abs kick back at last second before coming to stop. I think, well it's wet out but it is now doing it at every stop sign,bad sign.
I get about five miles from home and OD light is flashing. Now it is hard shifting even when letting off pedal.
I get home,turn it off go get scanner.1-2 shift malfunction but no blinking light before I plug in.
I clear code and take it for drive and light and hard shifting are back within quarter mile.
I had this kickback and abs light a few months ago and soldered and heat shrinked in a new rear abs sensor, I used glue lined 3 to 1 heat shrink.
Advise?
Not real deep but when getting off a highway they seem deep at that speed.
I experienced no problems immediately afterward which involved a couple of miles after puddle and about twenty miles back.
It sat afterwards in rain all day of course for about six hours. I drove it about ten miles shut it off for one hour. Upon returning home I get a tiny single abs kick back at last second before coming to stop. I think, well it's wet out but it is now doing it at every stop sign,bad sign.
I get about five miles from home and OD light is flashing. Now it is hard shifting even when letting off pedal.
I get home,turn it off go get scanner.1-2 shift malfunction but no blinking light before I plug in.
I clear code and take it for drive and light and hard shifting are back within quarter mile.
I had this kickback and abs light a few months ago and soldered and heat shrinked in a new rear abs sensor, I used glue lined 3 to 1 heat shrink.
Advise?