Just replaced all bushings on pedal box. Replaced throwaway bearing in the transmission as it was completely destroyed beyoud repair. That is a lot of work for simple "unable to disengage" clutch issue.
I am glad that I got to the point where I am almost done with everything but I noticed strange thing. I am not able to push the master clutch cylinder. It looks like that the push rod is being stuck. Not sure if that is normal or I just broke it without knowing what I had done.
For the pedal box, I am not sure if both sides should be at same position or just offset some degrees. Too bad that I didn't get chance to take a pix so I would review it later on.
Hope that someone chime in for the pedal position and stuck master clutch cylinder.
I am glad that I got to the point where I am almost done with everything but I noticed strange thing. I am not able to push the master clutch cylinder. It looks like that the push rod is being stuck. Not sure if that is normal or I just broke it without knowing what I had done.
For the pedal box, I am not sure if both sides should be at same position or just offset some degrees. Too bad that I didn't get chance to take a pix so I would review it later on.
Hope that someone chime in for the pedal position and stuck master clutch cylinder.