Hello, new to the forums here. Never really used them before.
So my hauler is an 88 F250 idi 2WD C6 133" wb. I am swapping in a borg warner T19 with a fixed output yoke. The donor was an 87 F350 6.9L rollback so I could'nt take the driveshaft and it did'nt have the long slip yoke tail housing I need. So now I need to find a 2 piece driveshaft and have it shortened.
My question is what would be the best truck to take it out of OR could I use a 1 piece with a slip yoke built in between the u joints from a newer truck and have it be long enough?
Any direction or advice appreciated. :brickwall:
So my hauler is an 88 F250 idi 2WD C6 133" wb. I am swapping in a borg warner T19 with a fixed output yoke. The donor was an 87 F350 6.9L rollback so I could'nt take the driveshaft and it did'nt have the long slip yoke tail housing I need. So now I need to find a 2 piece driveshaft and have it shortened.
My question is what would be the best truck to take it out of OR could I use a 1 piece with a slip yoke built in between the u joints from a newer truck and have it be long enough?
Any direction or advice appreciated. :brickwall: