ok so i pulled my truck in the garage this December because my only functioning fuel tank was leaking i replaced the tanks along with brazzing new pickup and return tubes in place of the old ones on the fuel tank sending unit. i slowly ended up putting a dana 60in, new brakes, lines, etc... it was all smooth sailing until i started it 2 weeks ago, i filled the fuel filter up, disconnected the glow plugs and cranked it while i bleed the air out at the #1 injector. it ran for about 10 minutes and died, i cant get it started again. there is fuel to the injector, and i replaced the lift pump, but still the same amount of pressure to the shrader on the ff housing. any ideas?
please bear with me, i dont have a lot of time to work on the old bear so it takes me about tripple the time than it should to do the work
please bear with me, i dont have a lot of time to work on the old bear so it takes me about tripple the time than it should to do the work